Roses have been cultivated for more than 5,000 years and are native only to the northern hemisphere: Europe, North America, East Asia, and the Middle East. They were grown as ornamental plants as far back as the 6th century BC in China. In Europe they were first grown for use in perfume and other cosmetics and as health aids, but their ornamental value was soon recognized and appreciated.
Rose breeding began in Europe in the 17th century. Most of the OGRs (Old Garden Roses) of that time were once-blooming shrubs in shades of white, pink, or red. The introduction of more and more species roses and the China and Tea groups into breeding practices produced reblooming roses in every color but true blue, with blooms of various shapes and sizes, ultimately resulting in thousands of cultivars meeting every conceivable aesthetic preference.
Roses require 1-2 inches of water a week to thrive. In dry climates, this water has to be supplied by the gardener, and although overhead watering was once discouraged, it is the logical choice. The water supplied by a gardener supplements rain, which falls from overhead. Overhead watering keeps the foliage and blooms clean, retards powdery mildew, and repels some pests.
Plant in early spring or fall, depending on your location. Space plants 2 to 3 feet apart, depending on the variety. Prepare the garden bed by using a garden fork or tiller to loosen the soil to a depth of 12 to 15 inches, then mix in a 2- to 4-inch layer of compost. In regions with cold (below 0F) winters, plant grafted roses so the graft union (which appears as a bulge near the base of the stem) is 1 to 2 inches below the soil line. In warm regions, the graft should be a few inches above the soil line.
For container-grown plants, dig a hole twice the diameter of the pot the plant is in. Carefully remove the plant from its container and place it in the hole. Carefully fill in around the root ball and firm the soil gently. For bare-root roses, dig a hole 12 to 18 inches deep and wide. The hole should be large enough that all the roots can be spread out without touching the sides of the hole. Mound a cone of soil in the center of the hole. Trim off any broken roots, then place the rose in the hole, spreading the roots around the soil mound. Fill the hole half full with soil and water it well to settle the soil and eliminate air pockets. Let the water drain, then fill the remainder of hole with soil and water thoroughly.
Good for cut flowers
Apply a layer of compost under the shrub each spring, followed by a 2-inch layer of mulch to retain moisture and control weeds, keeping mulch a few inches away from the stems. Water plants during the summer if rainfall is less than 1 inch per week. Pruning techniques vary with the type of rose.